|
|
 |
|
Customer Showcase
|
|
N9IW Tim Gustafson: Sister Bay, WI
The antennas are at 44, 74 and 116 ft. These heights were chosen based on modeling and the objective was to cover all the take off angles and not have any holes for any of the 5 ham bands!
Each of the log-periodics in the 3 stack are made up of 14 elements on 40 foot booms and cover 13.9 - 30 MHz. The antennas were designed and built by N9IW using EZNEC and YagiStress to optimized performance and survivability.
All three antennas use the following DX Engineering components: 3-inch DXE insulated Boom to Element Brackets; DXE Boom to Mast Plates, "which allow the antennas to be directly mounted to the rotating Rohn 55G tower"; DXE
Boom Support System Components and DXE Stainless Steel Saddle Clamps. The quality of the DXE components is excellent and the support staff is extremely prompt.
|
|
|
 |
 |
 |
 |
|
 |
 |
|
 |
. JH Richards
K8JHR
Wyoming, Michigan
USA
|
 |
| Get more information about this antenna >> |
 |
Be an Antenna Superstar!
You put a lot of time and effort into designing and building your DX Engineering-equipped antenna. So why not show the world what you have created by submitting it to the DX Engineering Antenna Showcase? It’s easy to do, too. Just click on the Entry icon above, fill out the information form--don't forget to include information about the DX Engineering products used on your antenna, attach some photos, and presto!--you’re an antenna superstar!
|
|
|
|
